Everyone is familiar with the wire drawing machine. Many of the supplies it produces are often used in our lives. So what are the operating procedures when using the wire drawing machine? Let’s take a look at it!
Operators must hold a wire drawing machine operation qualification certificate. Unlicensed personnel are strictly prohibited from operating on the machine. They must perform productive processing operations on fixed equipment. Non-machine personnel are strictly prohibited from operating on the machine or in tandem. Operators must be loyal to their duties, conscientious and responsible, be proficient in the operation, maintenance and upkeep of this equipment, constantly summarize and learn, strive to continuously improve their own quality, and be familiar with the basic operating parameters and performance indicators of this equipment. Before operation, the operator should wear gloves to prevent the workpiece from burning fingers and affecting product quality. The electrical equipment of the machine tool must be well grounded, and the two limit screws of the stroke block must be intact.
Lubricate each lubrication point no less than once per shift, and check the lubrication condition of each transmission part frequently. Before starting the machine, carefully check the air supply of the equipment, check whether the air supply pipeline is leaking, and drain the accumulated water in the air filter. The wire drawing machine and dust collection fan cannot be started at the same time, and the operator cannot leave the workplace after starting up. When two people are working, the operator behind the equipment must not face the exit of the wire drawing machine to prevent the workpiece from flying out and injuring someone. The pressure adjustment of the wire drawing machine should be moderate and it is strictly prohibited to cross the red line to avoid equipment or personal accidents. Carefully check whether the upper and lower bearing seats and the lifting screw are well lubricated, and make sure there is no one on the front side of the discharging machine before starting the machine. If an abnormality occurs during the operation of the equipment, it should be shut down and powered off in time to avoid the expansion of the fault.
After the equipment is started, you should promptly check whether the abrasive belt swing is within the required range and whether there are any other abnormalities. Otherwise, it should be adjusted or shut down in time. The drawings and operating information should be read carefully before processing to avoid batch scrapping or waste. Finished workpieces should be handled with care and packed with layered protection to avoid damage to the surface of the workpiece. It is necessary to carefully determine the drawing direction and drawing surface according to the operating requirements, and correctly select the drawing abrasive belt. The workpiece must be cleaned and then drawn, and the waste bin must be cleaned and recycled in time to ensure that the fan can work normally.
The above are the procedures for operating the wire drawing machine. Strictly following the procedures can not only reduce the risk of accidents, but also extend the service life of the machine and reduce the maintenance cost of the machine. I hope the above content can be helpful to everyone!
