Everyone has heard of the wire drawing machine. It is deeply loved by everyone because of its flexible operation and high practicality. Regular maintenance is very important in daily production. It can not only extend the service life of the machine, but also increase work efficiency. Let’s take you through how to maintain the wire drawing machine!
The wire drawing machine equipment should be inspected for safety before each start-up, and lubricating oil should be added regularly and quantitatively according to the lubrication chart. The oil should be clean and free of precipitation. After starting the machine, use purified and filtered compressed air to purge the machine tool. Pay attention to the cleaning of the inner surface of the conveyor belt and the surface of the workbench. There should be no foreign matter on the surface of the sand pad and sanding belt to avoid affecting the sanding accuracy. Frequently check the lubricating oil level of each reduction box. The lubricating oil should be replaced every six months. Bearings, transmission chains and sprockets should be refilled with lubricating grease every two weeks. Blow and wipe the abrasive belt swing control assembly, photoelectric tube and photoelectric switch regularly to avoid insensitive abrasive belt swing.
Pay attention to check the operating status of the equipment in time. If there is a problem with the steel wire drawing machine, deal with it in time. Every time the veneer wire drawing machine is stopped and restarted, the temperature in the temperature zone must be appropriate, otherwise the machine may be strained or damaged. Check the compressed air filter regularly and remove condensation from the filter. Check the air filter and add sufficient lubricating oil. The lubricating oil in the motor bearings should be replaced and refilled regularly, and the electrical parts should be checked regularly to see if they are working properly. Regularly check whether the pulleys, knobs, and buttons are damaged. If any seriously worn parts are found, replace them in time and report spare parts for replenishment.
Check the tension and wear of the narrow V-belt, the tension of the machine tool conveyor belt, the wear of the pneumatic brake pads, and the flatness of the workbench. During operation, if any abnormality is found in the machine, it should be stopped immediately and restarted after the fault is eliminated. To provide a good working environment and working condition for the equipment, regular cleaning work should be carried out to keep the machine tool of the steel wire drawing machine clean and hygienic, and appropriate anti-rust measures should be taken for the parts that are not painted. Regularly check and repair each switch and wire drawing mold to see if they are worn. Remember to lubricate regularly and quantitatively according to the lubrication chart before starting the machine.
The above is the maintenance of the wire drawing machine. Regular maintenance can not only extend the service life of the machine, but also reduce the risk of accidents in the machine, increase work efficiency and reduce maintenance costs. I hope the above content can be helpful to everyone. If If you need any products, please contact us. Welcome to call us!
